It is also controlled for nuclear non-proliferation and anti-terrorism considerations. In conjunction with carbon fiber with a rating at or above T, M60 fiber, or for that matter M-fiber with a lower rating, can be used to make carbon fiber rotors for gas centrifuges. Iraq pursued a centrifuge rotor using T and M40 fibers prior to the Gulf War. Zhang became directly involved in the sting operation after two brokers working on his behalf, a man and woman located in Taiwan, obtained, during a meeting in New York, samples of carbon fiber from the U. The U. He was placed under arrest at this meeting.
ADHESIVE BONDING OF CARBON FIBERS
Case Study — Carbon Fiber Helmet
A carbon fiber company in China was faced with the challenge of selecting an emission control system for a new pilot line at their specialty fiber products facility. The carbon fiber processor selected Anguil Asia because of their local presence in the region and specific design for this application. Before beginning the project, the Anguil team in Asia ran an energy analysis at the facility, which ensured that the proper technology would be applied based on the destruction requirements, efficiency needs and process parameters. To treat the higher concentration exhaust stream coming from the carbon fiber furnaces, Anguil designed a specialized multi-zone DFTO whereby the nitrogen compounds are disassociated at high temperatures in an oxygen depleted chamber. The furnace exhausts typically contain tar which often causes plugging in a standard emission control device. Special design considerations were taken to reduce these maintenance concerns and improve reliability.
Carbon Fiber Model Rocket
A supply chain is an organism. For an organism to thrive, each part—cells, organelles, atoms—must work together. Each part must work intimately, so that even the smallest problems are not only caught and corrected, but also avoided in the future, thus optimizing yield and driving out cost. Optimum Design Associates assembles electronics into a carbon fiber enclosure for a major aerospace manufacturer. The enclosure's structure is formed by bonding two carbon fiber pieces to an aluminum heat seak.